![]() ![]() At power-on status, long press SET button for 2 seconds, it will enter main menu as Figure-1:.lf the meter i s not accurate enough for some special occasion, it can set the upper and lower limit of the battery capacity through Programming Mode 3– via. ![]() The SET button on the meter backside can be used for setting and changing parameter.When the battery is connected to charger or high-current load for discharging, the displayed parameter w i l l fluctuate.The detected temperature value i s the temperature of the meter. The temperature unit can switch between ☌ and ☏.The displayed percentage is the battery remaining capacity percentage.The displayed voltage value i s the detected voltage value 10-100V, no external power source required.The 7 battery bars on the display, from right to left, indicate the battery remaining capacity from low to high.If set delay turning off, after powered on, the meter w i l l automatically t u r n off when reach the set delay time. At turned-off status, click the ON/OFF button, it w i l l wake up the meter. Click the ON/OFF button can t u r n off the meter.Power on the meter, it w i l l display battery capacity percentage, voltage and temperature.Connect the red wire to battery positive, the black wire to battery negative, make sure the contact i s firm.Connect the attached 1.25 terminal wire to the plug on the product backside.Technical Specifications Parameter Minimum Typical Maximum Unit Value WorkingĬonsumption 8 10 m A Backlight ON Adjustableĭimension mm 61.5.335.13.5 Installing Size mm 58.5.28.5 Display Size mm 33.16.5 If need to change the preset setting to apply it to other battery type, please set in strict accordance with the instruction. lt is used for 24V Lead-acid Battery by default.This unit i s a multi-tester which can be used to monitor battery capacity, voltage, temperature.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |